THERMOLAB .... One of the cooling manufacturer based in Taiwan is currently launching a new product again. Having previously named Baram which we know many versions of this series, among others, Baram, Baram Baram SHINE and 2010. This time named THERMOLAB TRINITY. Regarding the support processor is still the same as the previous all INTEL and AMD socket.
TRINITY THERMOLAB Specification
Full specifications can be seen in the figure below:
THERMOLAB reduce the amount of heat pipe in the series TRINITY into 4 pieces with heat pipes 6mm diameter. We know in Baram heat pipes used 5 pieces of heat pipes with a diameter of 8mm. However, on the base plate are already using Heat Pipe Direct Touch as in THERMOLAB Bada. With this technology prossecor heatsink surface in direct contact with the Heat Pipe HSF, heat absorption would be more optimal.
THERMOLAB TRINITY PICTURE
Click here to view the original image of 640x427px.
At first glance we see similar design TRINITY THERMOLAB THERMOLAB Baram. The top and bottom black THERMOLAB TRINITY, adds an elegant impression. Preparation of heat pipes is also not aligned, this is very good so the wind blowing directly from the FAN can be about all the heat pipes. Installation FAN use rubber fin embedded in the aluminum making it very difficult to replace the FAN, it seems to retail version that will go to Indonesia was not using the rubber, but using Clip FAN HSF BARAM. Adda 12V 0.4A FAN using the type = long-life bearings bearing hypro
TEST RESULTS
PERFORMANCE THERMOLAB TRINITY
TRINITY THERMOLAB performance in weight-bearing tests Prime95 Blend for 10 minutes is as follows: Here we show a comparison HSF also included in the tests: THERMALTAKE Frio, PROLIMATECH MEGAHALEM, SPIRE Thermax ECLIPSE